Fly to Hawaii, console into the switch, and then relax and have a drink with an umbrella in it.
Issue the show ip route command on the router connected to the switch.
Issue the show cdp neighbor command on the router connected to the switch.
Issue the show iparpcommand on the router connected to the switch.
Issue the show cdp neighbor detail command on the router connected to the switch.
The configuration register setting of 0x2102 provides what instructions to a router?
Tells the router to boot into ROM monitor mode
Provides password recovery
Tells the router to look in NVRAM for the boot sequence
Boots the IOS from a TFTP server
Boots an IOS image stored in ROM
The Acme Company uses a router named Gateway to connect to its ISP. The address of the ISP router is 206.143.5.2. Which commands could be configured on the Gateway router to allow Internet access to the entire network?
Gateway(config)#ip route 0.0.0.0 0.0.0.0 206.143.5.2
Gateway(config)#router rip
Gateway(config-router)#network 206.143.5.0
Gateway(config)#router rip
Gateway(config-router)#network 206.143.5.0 default
Gateway(config)#ip route 206.143.5.0 255.255.255.0 default
The Acme Company uses a router named Gateway to connect to its ISP. The address of the ISP router is 206.143.5.2. Which commands could be configured on the Gateway router to allow Internet access to the entire network?
Gateway(config)#ip route 0.0.0.0 0.0.0.0 206.143.5.2
Gateway(config)#router rip
Gateway(config-router)#network 206.143.5.0
Gateway(config)#router rip
Gateway(config-router)#network 206.143.5.0 default
Gateway(config)#ip default-network 206.143.5.0
What command will prevent RIP routing updates from exiting an interface but will still allow the interface to receive RIP route updates?
|
|
Router(config-if)#no routing
Router(config-if)#passive-interface
Router(config-router)#passive-interface s0
Router(config-router)#no routing updates
Which of the following statements are true regarding the command ip route 172.16.4.0 255.255.255.0 192.168.4.2?
The command is used to establish a static route.
The command is used to configure the default route.
The subnet mask for the source address is 255.255.255.0.
The command is used to establish a stub network.
Which of the following is the best description of the operation of split horizon?
Information about a route should not be sent back in the direction from which the original update came.
It splits the traffic when you have a large bus (horizon) physical network.
It holds the regular updates from broadcasting to a downed link.
It prevents regular update messages from reinstating a route that has gone down.