Parameter | Thread diameter d, mm | ||||||||
Thread pitch, mm | 1.0 | 1.25 | 1.5 | 1.75 | 2.0 | 2.5 | 3.0 | 3.5 | 4.0 |
Diameter D, mm near | 14.5 | 33.5 | 40.5 | 51.5 | |||||
Span S, mm | |||||||||
Height H, mm | 6.5 |
Table 12.11
Standard spring washers (GOST 6402-70)
Parameter | Thread diameter d, mm | ||||||||
Diameter d 0, mm | 6.1 | 8.2 | 10.2 | 12.2 | 16.3 | 20.5 | 24.5 | 30.5 | 36.5 |
Thickness s, mm | 1.4 | 2.0 | 2.5 | 3.0 | 3.5 | 4.5 | 5.5 | 6.5 | 8.0 |
Table 12.12
Bolt and screw length, mm
d | L / l 0 | d | L / l 0 |
Bolt length should be chosen from the following standard series, mm:
8, 10, 12, 14, 16, 20, 25, 30, 35, 40, 45, 50, 55, 60, 65, 70, 75, 80, 90, 100, 110, 120, 130, 140, 150, 160, 170, 190, 200, 220, 240, 260, 300.
Table 12.13
Dimensions of bolt joints
Parameter | Thread diameter d, mm | ||||||
a, not less | 1.25·d | ||||||
a1, not less | 3.5 | 4.5 | 5.5 | ||||
a2, not less | 2.5 | 3.5 | |||||
a3, not less | |||||||
a4 | 1.5… | 1.5 | 2… | 2… | 2.5… | 2.5… | 3… |
c | 1.6 | 1.6 | 1.6 | 2.5 | 2.5 | ||
D1 | |||||||
D2 |
Table 12.14
|
|
Lifting eye-bolts, mm
d | d1 | d2 | h | h1 | l | f | c | x |
M8 | 1.2 | 2.5 | ||||||
M10 | 1.5 | |||||||
M12 | 1.8. | 3.5 | ||||||
M16 |
Table 12.15
Inspection hole cover
A mm | B mm | A1 mm | B1 mm | C mm | C1 mm | K mm | R mm | Dimensions of screw | Number of screws |
- | M8x22 | ||||||||
- | M8x22 | ||||||||
M10x22 |
Table 12.16
Air vent, mm
D | d1 | d2 | D | h | l | a | H1 | H2 | a1 |
M12x1.75 | 5.5 | ||||||||
M16x2 |
Table 12.17
Air vent, mm
D | D | l | l1 | d1 | a | s |
M12x1.25 | ||||||
M16x1.5 | ||||||
M20x1.5 |
Table 12.18