Shop drawing of the output shaft

The shop drawing is carried out to scale 1:1 or 1:2. First of all, it is necessary to plot the output shaft according to the dimensions of assembly drawing. The shaft must be drawn in the position of installing on a machine, i.e. the axis of the shaft should be parallel to the main inscription. Transition from one installing diameter to the other is carried out by means of fillets or grooves. Fillets are used when the installing surface is not ground. Shaft portions where bearings are installed should be ground. As a space required for grinding wheel grooves are used. Possible alternatives of grooves are shown in table 14.1. Dimensions of grooves are given in table 14.1. In the shop drawing grooves should be represented to the increased scale separately.

Table 14.1